100% Acrylic Interior/Exterior Masonary & Wood Finish
This premium 100% acrylic finish designed for both interior and exterior. Elast-A-Crylic exhibits exceptional resustance to fade, chalk, mildew and acid rain. For us on properly prepared surfaces of wood and masonry as well as primed metal. This premium 100% acrylic flat finish is manufactured using the finest raw materials available, and will give you a beautiful completed project for many years to come. The flat finish and exceptional ability to toch-up, makes this an ideal product or concrete tilt-up buildings and masonry with cosmetic flaws.
White, as well as custom tinting full sprectrum of colors. Can also be manufactured in any color at factory in minimum of 100 gallon batches.
Quarts, Gallons, 5 Gallon Pails.
Properly primed wood, masonry and metal.
To Touch - 1 Hour.
To Recoat - 4 to 6 Hours.
Under normal weather conditions @70° F, 50% relative humidity.
By volume 36.09%.
250-400 sq ft per gallon depending on surface texture and porosity of surface.
All surfaces must be clean, dry and free of dust, loose paint and surface contaminants that may impair adhesion.
Recommended primers are listed below.
Block - #S105 Block Filler.
Drywall - #PV101 PVA Sealer.
Stucco - #7509 Efflorescence Blocker.
Tilt-Up or Brick - #95 Busan Acrylic Primer, #325 Draw Tite.
Wood (new) - #95 Busan Acrylic Primer, #78 High Build Undercoat, #63 Dynacoat Enamel Undercoat (interior only).
Wood (painted) - #300 Bus-Stop Acrylic Primer, #97 Selz².
Metal (ferrous) - #301 Rust Stop Red Oxide Primer, #302 Rust Stop White Primer.
Metal (non-ferrous) - #95 Busan Acrylic Primer, #302 Rust Stop White Primer, #300 Bus-Stop Acrylic Primer, #97 Selz².
Airless or conventional spray, brush or roll.
Does not exceed 50 grams per liter.
Small amount of clean water if required.
Soap and warm water clean up.