100% Acrylic Eggshell Finish Enamel (low sheen)
Acry-Sheen is a quality eggshell enamel made with 100% acrylic resin. It has good durability on both exterior and interior surfaces. Use it on exterior sash and trim as well as kitchen and bathroom walls and cabinets and trim throughout the home. Equally suitable for schools, hospitals and public buildings needing a durable satin finish. Acry-Sheen can also be manufactured speacial order as a Zero V.O.C. coatings.
White, Stock Colors and Tints. Factory custom colors with a 100 gallon minimum.
Quarts, Gallons and 5 Gallon Pails.
Properly primed wood, metal and masonry.
To Touch - 1 Hour.
To Recoat - 8 Hours.
Under normal weather conditions @70° F, 50% relative humidity.
350-450 sq ft per gallon depending on surface texture and porosity of surface.
All surfaces must clean, dry and free of dust, loose paint and surface contaminants that may impair adhesion.
By volume 37.06%.
Does not exceed 50 grams per liter.
Airless or conventional spray, brush or roll.
Recommended primers are listed below.
Block - #105 Block Sealer
Drywall - #PV101 PVA Sealer, #7509 "F" Stop.
Tilt-Up or Brick - #95 Busan Primer, #330 Draw-Tite.
Wood - #63 Dynacoat Enamel Undercoat (interior only), #300 Bus-Stop Primer, #97 100% Acrylic Primer.
Metal (ferrous) - #902 Red Oxide Primer, #905 Gray Primer.
Metal (non-ferrous) - #95 Busan Primer, #908 Zinc Phosphate, #300 Bus-Stop Primer, #97 100% Acrylic Primer.
Small amount of water if required.
Soap and warm water clean up (a rinse with lacquer thinner or brush cleaner may be necessary).